Geometry & Appearance
- Mould-defined form
- Heating and shaping
- Controlled annealing

Hot-bent decorative glass is shaped by heating a prepared glass blank over a mould and then annealing it. JEFF’s official information distinguishes this route from curved tempered glass and describes curved furniture, counters, washbasins and decorative objects as application directions.
A softened profile can be used to create continuous forms with fewer visual interruptions. Annealed hot-bent glass must not be treated as toughened safety glass by default. Geometry, support, edge treatment and any additional safety measures require confirmation for the intended use.
Source: JEFF official product information.
Original source resolution is limited; a high-resolution replacement is pending.

Furniture components and display counters; decorative interior objects; shaped washbasin concepts. Suitability for loads, impact or wet-area use is not assumed and must be assessed separately. Furniture image from JEFF’s official page. It illustrates hot-bent form development and is not a certified load-bearing specification.
General application examples; suitability and performance depend on the specified glass build-up. Reference photos are credited below and are not JEFF project claims.
| Process | Mould forming with annealing |
|---|---|
| Safety status | Not automatically toughened |
| Dimensions | Project-specific |
Talk to our team about your glass design, specifications and project needs.